Underground Root Ball Support Kits

In stock
SKU
RB-kits
Grouped product items
Product Name Part# CapacityTree Size Qty
400 Underground Root Ball Kit
$23.00
3A-EK4001 300 lbsUp to 2" diameter
680 Underground Root Ball Kit
$48.00
3A-EK6801 1100 lbsUp to 3" diameter
880 Underground Root Ball Kit
$64.00
3A- EK880 3000 lbsUp to 6" diameter


400 Underground Root Ball Kit

Part # 3A-EK4001
Capacity 300 lbs
Tree Size Up to 2" diameter
Material die cast aluminum anchor, galvanized cable, webbed strap
Cable Size 20" x 1/16"
Package Contents 1 Tree Kit: 3 BBP anchors with D-ring attached galvanized steel cable and 1 strap with hand ratchet

680 Underground Root Ball Kit

Part # 3A-EK6801
Capacity 1100 lbs
Tree Size Up to 3" diameter
Material BBP die cast aluminum anchor, galvanized cable, webbed strap with hand ratchet
Cable Size 30" x 1/8"
Package Contents 1 Tree Kit: 3 BBP anchors attached galvanized steel cable with D-ring and 1 strap with hand ratchet

880 Underground Root Ball Kit

Part # 3A- EK880
Capacity 3000 lbs
Tree Size Up to 6" diameter
Cable Size 42" x 3/16"
Package Contents 1 Tree Kit: 3 anchors attached galvanized steel cable with D-ring and 1 strap with ratchet

Better Bilt Products designed their underground root ball support kits to secure trees and shrubs in place by the root mass. They keep new plantings in a straight, upright position with none of the problems of traditional cabling systems.

Use these kits for anchoring plants in locations where staking and cabling is unsafe or simply not an option. They are great for anchoring plants in tight areas or along walkways and roads. They provide a much safer setup for public areas like parks and schools!

This kit provides all of the components needed to anchor one tree. Each kit includes:

  • (3) Earth anchors & pre-assembled with wire cables and D-rings
  • (1) Hand-ratchet strap

Choose your desired diameter below.

Installation instructions:

Step One: Dig out the area — allow for extra work space to install the anchor points.

Step Two: Drive the earth anchor into the ground until only the cable loop and D-ring remain above ground.

Step Three: Set the anchor by pulling up on the D-ring until you notice no additional movement.

Step Four: Position the tree in the center of the anchor points.

Step Five: Thread the strap through the D-rings in the desired pattern.

Step Six: Tighten the strap and backfill!

Write Your Own Review
You're reviewing:Underground Root Ball Support Kits
Copyright © Better Bilt products All rights reserved. Site by Mandle Design, Inc.